Site surveys across Dubai & Northern Emirates
+971 50 646 3043 has@fastfixdxb.com Monday – Saturday · 8:00 AM – 6:00 PM
Turkish hammam with a heated marble slab and a fibre optic domed ceiling

Turkish hammam construction in Dubai

A hammam is not a steam room with marble in it. The heat comes up through the stone, the humidity is lower than a steam room, and the whole room is built around a heated slab that people lie on for an hour at a time.

40–45°C  /  80–100% RH

We build Turkish hammams in Dubai for private villas, hotel spas and wellness centres. This is specialist work: heated stone, tanked construction and stone-setting to fine tolerances, all in the same room. It is the most demanding thing we install and the one where experience shows most clearly. Part of our sauna and steam room installation work across Dubai.

How a hammam is put together

The heated slab

Underfloor heating circuits are laid in a reinforced screed, pressure-tested, then covered with the marble platform. The slab surface holds a steady, comfortable warmth rather than a fierce heat, because people lie directly on it for long periods. Getting that temperature right is a matter of circuit spacing and flow control, not of turning a thermostat up.

Stone selection and setting

Marble is the tradition, and large-format porcelain that convincingly imitates it is a legitimate modern alternative at a fraction of the cost and weight. Whichever is chosen, joints are tight, falls are built into the setting bed, and every cut edge is honed. Poorly set stone in a wet room telegraphs every mistake once the surface is wet and lit.

The domed or vaulted ceiling

Not decoration. The curve carries condensation to the perimeter rather than dropping it on the person below, exactly as a fall does in a rectangular steam room. Traditional hammams have small glazed openings in the dome; we replicate the effect with fibre optic lighting, which is maintainable and does not perforate the waterproofing.

Waterproofing and drainage

Full tanking to every surface, flood-tested before stone. Floor falls to drain across the whole room, because a hammam is washed down, not just used. Basins are fed with tempered water and set at working height.

Specification

ElementWhat we specify
Operating climate40-45°C air, 80-100% relative humidity
Göbektaşı slabMarble or large-format porcelain over heated screed
Slab heatingWet or electric underfloor circuits, zoned and controlled
CeilingDomed or vaulted, tanked, fibre optic lighting
BenchesHeated perimeter seating, stone or solid surface
Steam supplyGenerator sized to volume, low-level outlet
BasinsTraditional kurna basins with tempered feed
WaterproofingFull tanking, flood-tested, falls to drain throughout
StructureLoading assessment where required

What it costs

ScopeIndicative installed priceProgramme
Compact private hammamAED 60,000 - 110,0004-6 weeks
Full hammam, marble slab and domeAED 120,000 - 280,0006-10 weeks
Commercial hammam suiteOn application8-14 weeks
Porcelain alternative to marbleSaves 25-40%Shorter lead time
Where the money goes. Stone. A bookmatched marble slab can cost more than the entire rest of the room, and lead times on a specific block run to months. Large-format porcelain gets you most of the appearance for a fraction of the cost and weight, and in an apartment the weight saving may be what makes the project possible at all.

Hammam or Moroccan bath?

They are often confused. A Turkish hammam is the heated stone slab and dome described here. A Moroccan bath is a steam-and-scrub treatment room, typically with tadelakt walls and a heated treatment bed, and it is a smaller and less structural build. If you want a treatment room for a salon, that is the page you want. If you want the architectural room, stay here. For the simpler option again, see steam room installation.

Where we build

Hammams across Dubai, Abu Dhabi, Sharjah, Ajman and Ras Al Khaimah. For hotel and spa projects see commercial spa fit-out.

Frequently asked questions

What is a gobektasi?

The heated marble platform at the centre of a traditional hammam, on which the bathing and scrubbing takes place. It is a raised slab, warmed from below by underfloor heating circuits laid within a screed, and it is the defining element of the room. Everything else, the basins, the benches and the domed ceiling, arranges itself around it.

How is a hammam different from a steam room?

A steam room runs at 43 to 46 degrees with saturated humidity and everyone sits. A hammam runs slightly cooler in the air, around 40 to 45 degrees, with heat radiating up from the stone, and the experience is lying down for an extended treatment. Structurally the difference is the heated slab and the far greater weight of stone, which changes the floor build-up and often the structural loading.

How long does a hammam take to build?

Four to eight weeks. The stone is the long lead item, particularly for a bookmatched slab, and the underfloor circuits have to be laid, pressure-tested and screeded before any stone goes down. It is the most involved room we build and it does not respond well to compression.

Does a hammam need structural approval?

Often, yes. A marble slab with screed and heating build-up is heavy, and in an apartment or on an upper floor the loading needs checking against the structural design. We arrange the assessment and prepare the submission where one is required.

What does a hammam cost in Dubai?

From around AED 60,000 for a compact private room, and AED 120,000 upward for a full commercial hammam with a bookmatched gobektasi, domed ceiling and multiple basins. Stone selection is the single largest variable and it can double the figure on its own.

Can a hammam go in a private villa?

Yes, and we build them regularly. The practical requirements are floor loading, a drain, a route for the steam supply and enough footprint for a slab people can lie on, which realistically means about 3 by 3 metres as a minimum for the room.

Related

Often specified alongside this

40–45°C / 90–100% RH

Moroccan Bath

Tadelakt walls, heated treatment beds and steam supply for salons and villa wellness suites.

Read more
43–46°C / 100% RH

Steam Room Installation

Fully tanked, tiled or acrylic steam rooms at 100% humidity — vapour barrier, fall-to-drain and generator sizing done properly.

Read more
Multi-zone / Multi-zone

Commercial Spa Fit-Out

Hotels, gyms and clubs — multi-cabin thermal suites delivered with drawings, approvals and handover documentation.

Read more
43–45°C / 100% RH

Steam Shower

Convert an existing shower into a sealed steam enclosure — glass, generator, seat and drainage in one visit.

Read more

Book a free site survey

Thirty minutes on site tells us more than an hour on the phone — and it is the only way to give you a price that does not move.

WhatsApp us