Steam Room Installation
Fully tanked, tiled or acrylic steam rooms at 100% humidity — vapour barrier, fall-to-drain and generator sizing done properly.
Read more
Almost every steam generator we are called to in Dubai has the same problem, and it is not a manufacturing fault. It is scale. Hard water coats the element, output falls away, and eventually the unit cuts out for good.
We install, service and repair steam generators throughout Dubai and the Northern Emirates for homes, hotels, gyms and salons. Diagnosis first, then a clear recommendation on whether to repair or replace, with the reasoning explained. Part of the sauna and steam room installation service we run across Dubai.
Dubai's water supply is hard. Every litre a generator boils leaves mineral behind, and that mineral bonds to the heating element as a hard white crust. The crust insulates the element from the water, so the element runs hotter to produce the same steam, and eventually it fails. Along the way the level probes fur up and start misreading, which produces the intermittent faults people describe as the unit having a mind of its own.
The fix is not clever. It is descaling on a schedule appropriate to the local water rather than to a European service manual, plus an auto-drain that actually functions so the tank empties after every session instead of sitting full and concentrating.
| Service | What it covers |
|---|---|
| Diagnosis | Element, probes, solenoid, drain valve, control board, supply |
| Descaling | Full tank and element clean, probe service, drain test |
| Element replacement | Genuine parts for common Tylö, Harvia, Steamtec models |
| Control repair | Panel and board replacement, sensor recalibration |
| New installation | Sizing, positioning, insulated pipe run, commissioning |
| Relocation | Moving units sealed into inaccessible positions |
| Water treatment | Softener or inline treatment to slow scale formation |
| Room volume | Typical generator | Notes |
|---|---|---|
| Up to 3 m³ | 4.5 - 6 kW | Small steam shower |
| 3 - 5 m³ | 6 - 9 kW | Domestic steam room |
| 5 - 8 m³ | 9 - 12 kW | Larger domestic or small commercial |
| 8 - 14 m³ | 12 - 18 kW | Commercial, continuous duty |
| Stone or glass surfaces | Add 20-30% | Cold surfaces absorb output |
| Scope | Indicative price | Timing |
|---|---|---|
| Diagnostic visit | AED 350 - 600 | Within 48 hours |
| Descale and service | AED 650 - 1,400 | Same visit |
| Element replacement | AED 900 - 2,800 | Within a week |
| Control panel replacement | AED 1,200 - 3,500 | Within a week |
| Generator supply and install, 6-9 kW | AED 6,500 - 15,000 | 1-2 weeks |
| Generator supply and install, 12-18 kW | AED 15,000 - 32,000 | 2-3 weeks |
If the room itself is failing rather than the generator, see steam room installation and steam shower installation. To stop this recurring, an annual maintenance contract covers scheduled descaling. The sauna equivalent is sauna heater supply and replacement.
Steam generator repair across Dubai, Abu Dhabi, Sharjah, Ajman and Ras Al Khaimah.
In order of likelihood: scale on the heating element, a blocked or failed auto-drain valve, a faulty water level probe reading incorrectly because of scale build-up, a failed solenoid on the fill line, or a burnt-out element. All but the last are repairable, and the last is usually caused by the first. A diagnostic visit establishes which within the hour.
Every three to six months in domestic use, and every one to three months in commercial use. Dubai water is hard, and scale accumulates far faster here than the manufacturer's European service interval assumes. Following the manual rather than the local water condition is why so many units fail early.
Most can be repaired. Elements, probes, solenoids, drain valves and control boards are all replaceable on the common Tylo, Harvia and Steamtec models. Replacement makes sense when the unit is over ten years old, when it was undersized for the room from the start, or when the cost of parts approaches the cost of a new unit.
Sized to room volume, adjusted for cold surfaces. As a guide, around 6 kW for 3 cubic metres, 9 kW for 5, and 12 kW for 8. Natural stone, a glass wall or an external wall each increase the requirement. Ceiling height is what usually catches people out, because volume grows faster than floor area suggests.
We aim for a diagnostic visit within 48 hours across Dubai and the Northern Emirates, and for commercial clients on a maintenance contract we prioritise same-day where possible, because a closed spa room is lost revenue every hour.
Yes, provided the unit is suitable for the room. We will check the sizing and the intended position first, and if it is wrong we will say so before installing rather than after. Installing an undersized generator correctly still produces a room that does not work.
Fully tanked, tiled or acrylic steam rooms at 100% humidity — vapour barrier, fall-to-drain and generator sizing done properly.
Read moreConvert an existing shower into a sealed steam enclosure — glass, generator, seat and drainage in one visit.
Read moreQuarterly descaling, element checks and timber care — annual contracts that keep a room out of downtime.
Read moreHeated marble göbektaşı slabs, domed ceilings and radiant benches built by tilers who have done it before.
Read moreTadelakt walls, heated treatment beds and steam supply for salons and villa wellness suites.
Read moreGenuine Harvia, Tylö, Sawo, EOS and Helo heaters and control panels — sized to your cabin volume and DEWA load.
Read moreThirty minutes on site tells us more than an hour on the phone — and it is the only way to give you a price that does not move.