Finnish / Traditional Sauna
Nordic spruce and thermowood cabins with Harvia, Tylö or EOS heaters — 80–100°C dry heat, built to Dubai Municipality standards.
Read more
Anyone can put cold water in a tank. Holding it at 5 degrees through a Dubai August, without the chiller running permanently and without the running cost becoming absurd, is an engineering problem, and it is the one most installations here get wrong.
4–15°C / —
We install cold plunge pools across Dubai for private villas, gyms, recovery studios and hotel spas. Self-contained units where space is tight, built-in plunges with remote plant where the design allows. The specification always starts from the same question: what ambient temperature does this have to fight, and for how many months of the year. Part of our full sauna and steam room installation service in Dubai.
Chiller capacity is quoted against an assumed ambient temperature. Specify against a European summer and the same unit in Dubai will run continuously from June to September, never quite reach setpoint, and shorten its own life doing it. We size against local ambient with headroom, which usually means a larger unit than the catalogue suggests and a longer service life as a result.
This matters more than chiller size. An uninsulated tank in 45 degree air is a heat exchanger working against you all day. Closed-cell insulation to the tank body, the base and the pipework, plus an insulated lid, is what turns the running cost from painful into trivial. The lid alone makes a startling difference.
Chillers reject heat and need airflow. Boxed into a sealed cupboard or sitting in full afternoon sun, the unit is trying to dump heat into air that is already hotter than its target. Shaded, ventilated, accessible for servicing.
| Element | What we specify |
|---|---|
| Operating temperature | 4-15°C, adjustable |
| Chiller | Sized against 45-48°C ambient with headroom |
| Tank | Acrylic, stainless or tiled; closed-cell insulated throughout |
| Lid | Insulated cover — the single biggest running cost saving |
| Pipework | Short runs, fully insulated, shaded where external |
| Filtration | Cartridge or sand, turnover matched to bather load |
| Sanitisation | Ozone or UV with low residual |
| Electrical | RCD-protected dedicated circuit, IP-rated isolation |
| Steps and grab rail | Non-slip entry; essential at these temperatures |
| Scope | Indicative installed price | Programme |
|---|---|---|
| Self-contained plunge, 1-2 person | AED 18,000 - 35,000 | 2-3 weeks |
| Built-in plunge with remote chiller | AED 35,000 - 60,000 | 4-6 weeks |
| Commercial recovery plunge | From AED 55,000 | 5-8 weeks |
| Chiller retrofit to existing plunge | AED 12,000 - 28,000 | 1-2 weeks |
Cold plunge pools across Dubai — Palm Jumeirah, Emirates Hills, Dubai Hills Estate, Al Quoz recovery studios and Business Bay gyms — plus Abu Dhabi, Sharjah, Ajman and Ras Al Khaimah. For gym and hotel projects see commercial spa fit-out.
Yes, but only with a chiller sized for the ambient conditions here and a properly insulated tank. A unit specified from a European catalogue will run continuously in July, fail to reach setpoint, and burn out early. We size for a 45 to 48 degree ambient and insulate the tank, the pipework and the lid, so the chiller cycles rather than runs flat out.
Between AED 18,000 and 35,000 for a good self-contained one to two person unit installed, and AED 35,000 to 60,000 for a built-in plunge with a remote chiller and full filtration. Commercial installations with recovery-grade filtration and higher turnover cost more.
Considerably less than people expect, if it is insulated. A well-specified domestic plunge with a lid typically draws a few hundred dirhams a month in summer and much less in winter, because a chiller only works when heat gets in. Skimp on insulation and that figure multiplies, which is the real reason insulation matters more than chiller size.
Somewhere shaded, ventilated and accessible. A chiller rejects heat, so putting it in a sealed cupboard or in direct afternoon sun means it fights itself. Pipe runs are kept short and fully insulated, because every metre of uninsulated line in 45 degree air is heat walking straight into your cold water.
Filtration plus sanitisation, usually ozone or UV supported by a low residual. Cold water holds oxygen well and is less hospitable to bacteria than warm water, but a plunge used by several people daily still needs proper turnover. For commercial use the filtration and turnover rate are specified to the expected bather load.
That is the arrangement most clients end up wanting, and building them at the same time is materially cheaper because the groundwork, drainage and electrical route are shared. A plunge beside a sauna also gets used far more than one on its own.
Nordic spruce and thermowood cabins with Harvia, Tylö or EOS heaters — 80–100°C dry heat, built to Dubai Municipality standards.
Read moreAcrylic and built-in spas with balanced circulation, sand or cartridge filtration and safe electrical isolation.
Read moreGarden and rooftop cabins in thermo-treated pine, UV-sealed and weather-detailed for 50°C summers and coastal salt air.
Read moreLow-temperature far-infrared cabins on a 13A socket — no plumbing, no three-phase supply, ideal for apartments and clinics.
Read moreHotels, gyms and clubs — multi-cabin thermal suites delivered with drawings, approvals and handover documentation.
Read moreQuarterly descaling, element checks and timber care — annual contracts that keep a room out of downtime.
Read moreThirty minutes on site tells us more than an hour on the phone — and it is the only way to give you a price that does not move.